Installation
Revised 2015-12-04
2-8
N-Tron® 300 Series Hardware Guide
Connections
Power Connection
1.
Unscrew & Remove the DC Voltage Input Plug from the top header.
2.
Install the DC Power Cables into the Plug (observing polarity on unit).
3.
Plug the Voltage Input Plug back into the top header.
4.
Tightening torque for the terminal block power plug is
0.22 Nm/0.162 Pound Foot
.
5.
All LED’s will flash ON Momentarily.
6.
Verify the Power LED stays ON (GREEN).
Note:
Either V1 or V2 can be connected to power for minimal operation. For redundant power
operation, V1 and V2 plugs must be connected to separate DC Voltage sources. Use wire sizes of
16-28 gauge. The power cord should be limited to less than 10 meters in order to ensure optimum
performance.
Recommended 24V DC Power Supplies, similar to:
100VAC/240VAC:
N-Tron series NTPS-24-1.3, DC 24V/1.3A
