Product Code: RLBRK10
Made in China to TQB Brands Pty Ltd specifications
Page 3
Visit us at www.tqbbrands.com.au
SAFETY INSTRUCTIONS
SAFETY OPERATING INSTRUCTIONS
-
Safety related decals must be maintained and replaced if they become hard to read.
-
Wear eye protection that meets approved standards.
-
This equipment is designed for vehicle body / frame applications. Using this
equipment in an application for which it is not designed could result in overloading,
reduced load capacity, reduced stability and /or system failure.
-
Do not overload the hydraulic system; creating pressure beyond the rated capacity of
the pump and ram may result in personal injury. Overloading is indicated by bowing
extension tubes or slipping attachments.
-
Some components in this set do not match the maximum pressure rating of the pump
and ram. USE A PRESSURE GAUGE IN THE SYSTEM TO MONITOR HYDRAULIC
PRESSURE (not included). Refer to the instructions in this document for typical
applications and load capacity.
-
Do not over extend the hydraulic arm, over extending the spreader ram may force the
plunger out of the ram, causing damage.
-
Before working on a vehicle always set the parking brake and chock the wheels.
-
Attachments and extension tubes must be aligned and fully engaged so ram force is
straight, avoiding an off centre load condition.
-
When servicing, use only Red Label identical replacement parts. Use of any other parts
will void the warranty.
-
Use the right product for the job. There are certain applications for which the hydraulic
body repair kit was designed. Do not modify the hydraulic body repair kit and do not
use the Hydraulic body repair kit for a purpose for which it was not intended.
Ram Safety Instructions:
-
Ram must be on a stable base which is able to support the load while pushing or
lifting. Use shims, friction material or constraints to prevent slippage of the base or
load. Ensure ram is fully engaged into/onto adapters & extension accessories.
-
Centre load on ram. Distribute load evenly across the entire saddle surface. Do not
allow off-centre loads on a ram as this may cause the load to tip or the ram to kick
out.
-
Completely retract the ram before opening the filler screw on the pump to add
hydraulic fluid. An overfill can cause personal injury due to excess reservoir pressure
created when rams are retracted.
