Service And Repair
Replacing the Packer-to-Manifold Wiring Connectors
35
Figure 30. Packer-To-Manifold Wiring Connectors
6.
Use a pair of needle nose pliers to remove the retaining washer that holds the male connector in its socket.
7.
Remove the male connector.
8.
Get the new male connector and retaining washer from the electrical connector kit.
9.
Notice the small indexing pin on the back of the male connector (see Figure 31).
Figure 31. Male Connector’s Indexing Pin
10. The indexing pin on the back of the connector must seat in the index hole in the base of the male connector’s
socket (see Figure 32) for the connector to be correctly oriented relative to the female connector.
11. Place a mark on the facing of the Packer using a felt pen to indicate the position of the index hole (see
M
a
le connector
M
a
le connector'
s
ret
a
ining w
as
her
Fem
a
le connector
rjp
u
mp
s
/fig42.ep
s
M
a
le connector'
s
indexing pin
Wiring to UMP
Indexing pin
rjpumps/fig43.eps