RESET AND PROGRAM OPTIONS
Connecting a wire from the RST EN (Reset Enable) or the HS (Program
Enable) Input terminals to Common will enable the front panel Reset or
Program buttons respectively.
Pulling the “RST.” input low causes the timer to reset. The “RST.” can be
pulled low by either a mechanical switch or solid-state transistor switch. The
Switch load is 15
μ
A (max. voltage drop 0.5 V) when ON. The OFF-state
leakage current must be less than 2
μ
A.
Note: The RC protection circuit on the “RST.” Input causes a delay of
approximately 15 msec in Reset response.
+3V
MICRO
CHIP
COM
0.022µF
220K
220K
BATT.
3.0V
RST.
COM/NEUTRAL
R
RST. EN.
FRONT
PANEL
RESET
HS
PROGRAM
REMOTE
RESET
P
APPLICATION
A bottling company has a preventive maintenance program
based on the accumulative running hours. For each bottling
line, they added a CUB7T000. When the line is running a
contact closure is given to the CUB7T timer allowing the new
time to accumulate with the hours of previous operations. At a
designated value, the line maintenance is performed and the
CUB7T is reset with a key switch to 0.
BACKLIGHT OPTION
Optional backlight versions of the CUB7T require an external 9 to 26
VDC power supply. The external supply is connected between the V+ and
common terminals as shown in the drawing.
HS-6
V+-2
5-RST
1-COM
3-RST EN
LS-4
9-26 VDC
POWER SUPPLY
(Backlighting)
+
-
LIMITED WARRANTY
The Company warrants the products it manufactures against defects in materials and
workmanship for a period limited to two years from the date of shipment, provided the
products have been stored, handled, installed, and used under proper conditions. The
Company’s liability under this limited warranty shall extend only to the repair or
replacement of a defective product, at The Company’s option. The Company disclaims
all liability for any affirmation, promise or representation with respect to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify
RLC against damages, claims, and expenses arising out of subsequent sales of RLC
products or products containing components manufactured by RLC and based upon
personal injuries, deaths, property damage, lost profits, and other matters which Buyer,
its employees, or sub-contractors are or may be to any extent liable, including without
limitation penalties imposed by the Consumer Product Safety Act (P.L. 92-573) and
liability imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L.
93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products
except those expressly contained herein. The Customer acknowledges the disclaimers
and limitations contained herein and relies on no other warranties or affirmations.
HS-6
V+-2
5-RST
1-COM
3-RST EN
LS-4
CONTACT
CLOSURE
ORDERING INFORMATION
MODEL NO.
DESCRIPTION
PART NUMBER
*
CUB7T
CONTACT
INPUT
Timer; Positive Image Reflective
CUB7T000
Timer, w/Yel-Grn Backlighting
CUB7T010
Timer; w/Red Backlighting
CUB7T020
BNL
Replacement 3 V Lithium Battery
BNL10000
*
Battery is included with unit.
