T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
Energy Saving Bulkhead
with PIR
Installation Instructions P.2
For models: LF13PIR
Installation
Installation of the Bulkhead light, please refer to the Fig.2.
1.
Installation by a licensed electrician and according to IEC Wiring Regulation.
2.
Switch the power off at the mains supply and ensure that there is no power to the lamp.
3.
Remove the Diffuser using a Screwdriver, see figure.
4.
Unscrew the Screw (A) and remove the Transparent Plate.
5.
Mark the mounting hole positions on the wall. Drill and plug the wall at the marked positions. Screw the lamp body to
the wall with suitable mounting screws (supplied).
6.
Connecting the main power wires to the Terminal Block (see the relative symbols - Fig.2), the Cable must pass through
the Wiring Rubber Gasket.
7.
Insert the Max. 60W / 230V~50Hz incandescent Bulb into the Lamp holder (E27).
8.
Re-screw Transparent Plate.
9.
Re-fit the Diffuser by hand.
10.
After finishing the mounting, you can adjust the detection area and working state of the PIR Sensor.
Fig.2. Mounting & Wiring to Terminal
NOTES FOR ELECTRICIAN - Installation must be carried out by a qualified
Electrician
1.
The Bulkhead Light should be wired to its own lamp switch. Do not interconnect with other lights on the same switch.
2.
Do not connect to Dimmer.
Red Arrow Trading
Elsworth House, Herries Road South, Sheffield,
S6 1QS
