22W LED Emergency Wilson
Bulkhead with Microwave
Sensor Corridor Function
Installation Instructions P.1.
For models: WIL22LEDEMSCF
This installation must be carried out by an electrician.
Please read these instructions carefully before installation.
Leave a copy for the user/maintenance engineer for future reference.
Important Installation Information
•
Installation should be carried out in accordance with the
latest edition of the I.E.E. wiring regulations (BS7671) and
taking into consideration the latest Building Regulations. If
in doubt, consult a qualified electrician.
IMPORTANT: Ensure that ALL electrical connections
are tight with no loose strands, including factory made
connections.
•
All luminaires run hot. It is the installer’s responsibility to
consider fire risk and take appropriate precautions.
•
Input voltage – 220-240v 50HzAC
•
The luminaire must not, under any circumstances, be
covered with any insulation materials and luminaires must
not be installed close to flammable materials.
•
Before commencing installation or maintenance, ensure
electricity is switched off at the mains.
Specification
•
Bulkhead LED fitting
•
Class I (must be earthed)
•
Lamp type: 264 SMD LEDs
•
Colour Temperature: 4000K
•
IP20 Rated.
•
Supply voltage: 220-240v
•
Polycarbonate Diffuser & powder coated Steel Base.
Important User Information
•
Always switch off mains supply before servicing.
T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
•
Remove the Diffuser cover from the body.
•
Feed the power cables into the enclosure.
•
Fix the base to the wall or ceiling as required. Locate
joists, be aware of water pipes and electric cables when
applying the fixing screws.
•
Connect the mains supply cables to the terminal blocks
supplied as follows:
•
Permanent LIVE 1 - to terminal marked L1.
•
Switched LIVE 2 - to terminal marked L2.
•
NEUTRAL - (blue) to terminal marked N.
•
EARTH - (green / yellow) to terminal marked N.B. These
luminaires
must
be earthed.
•
Please Note: For Emergency versions there will also be
an un-switched permanent LIVE which is connected to the
terminal marked Permanent Live.
•
Ensure there are no exposed conductors, loose strands or
trapped insulation.
•
Refit the diffuser cover.
•
Switch on the power supply.
Microwave Sensor
The Microwave Sensor has 3 dials (lux level, time & sensitivity
range). Adjust the dials to suit your requirements and
maximise energy savings.
Red Arrow Trading
Elsworth House, Herries Road South,
Sheffield, S6 1QS
Installation Instructions
•
Select the required position for the luminaire and provide
a suitable power supply to this point, taking into account the
possible power entry points of the luminaire.
