INSTALLATION INSTRUCTIONS
IMPORTANT: Ensure that ALL electrical connections are tight
with no loose strands, including factory made connections.
1. Ensure there is adequate free air circulation of at least 100mm
around the fitting. All fittings run hot. It is the installer’s
responsibility to consider any fire risk and take appropriate
precautions.
2. The nearest illuminated surface must be at least 0.5m from
the front of the fitting.
3. Check for concealed cables before drilling any fixing holes.
4. Remove the bracket by removing the two bolts.
5. Fix the bracket to a wall or similar hard surface.
6. Fix the body to the bracket using the two bolts.
4TH WIRE INSTALLATION INSTRUCTIONS
This LED AC Driverless Floodlight with P.I.R is equipped with a
4th wire (Brown). This wire can be used in one of two ways:
1. Connected to a switch (as per diagrams on reverse), when
switched on will bypass the PIR and the LED AC Driverless
Floodlight will remain on until switched off.
2. Connected to subsequent non-PIR Light fittings in order to
switch these on as well (Black wire is the supply wire, Neutral
and Earth wires to also be taken to secondary fittings).
NOTE: If the 4th (Brown) wire is not required it must be
terminated safely, when the PIR is activated it will
become live. Total load including master must not exceed
100W.*
INS
TALLA
TION INS
TRUCTIONS
Red Arrow Trading
Elsworth House, Herries Road South
Sheffield, S6 1QS
T: 0800 195 0006 F: 0870 195 0006
www.redarrowtrading.com
LED AC DRIVERLESS FLOODLIGHTS
WITH PIR
FOR MODEL: FLAC10BPIR, FLAC20BPIR, FLAC30BPIR & FLAC50BPIR
SAFETY WARNING
• The installation should be carried out by a qualified electrician in compliance with the current edition
of the IEE Wiring Regulations.
• Prior to installation carry out the necessary risk assessment considering the people who could be at
risk, the level of risk and the precautions required to control the risk.
• Ensure that the circuit supply is isolated either by the circuit supply fuse being removed or the
applicable circuit breaker being turned off before installation or any maintenance.
• Check the total load on the circuit including the luminaire does not exceed the rating of the circuit
cable, fuse or circuit breaker.
• If the fitting incorporates control gear, ensure careful sizing to avoid instances of nuisance tripping of
the protective device used in the installation.
•
Follow the provided installation instructions, using the fixings supplied or recommended.
