ATTENTION!
※
The housing Mode Dial is designed to turn the camera's mode dial back and forth via
friction from the o-ring that comes in contact with the mode dial inside the housing. When
installing or removing camera pull Mode Dial up. When installing be sure to place the Dial
contact in the proper position. Should the internal Control Wheel begin to slip, use a soft
dry cloth to wipe away any oil and other contaminates that may cause the loss of friction.
※
Please refer to camera manual for explanation of Control Dial and Control Ring Dial.
※
Use Strobe Mask-External Strobe Connection Mount as required for attaching fiber optic
flash cables. Be sure to attach Diffuser and shown above.
※
Attached Diffuser using the grooved provided on the Lens Port.
NOTE:
During use make sure the housing Mode Dial is down.
HOW TO DISASSEMBLE, CLEAN AND LUBRICATE CONTROL RING DIAL
※
The Control Ring Dial can be removed to lubricate the internal moving parts and to clean
away sand, mud or other contaminants when dial does not turn smoothly.
1. Remove Port Protection Ring by unscrewing it from the Lens Port.
2. Using the Dial Locking Ring Tabs turn Dial Locking Ring to the left (counterclockwise) until
it stops.)
3. Holding the Control Ring Dial, gently lift Dial and Locking Ring off Lens Port as shown
below.
3
Summary of Contents for WHS-RX100Mk II
Page 12: ...MEMO...
