Recsea WHC-G1XMkIII, Manual

Page: 9 / 12

1. Using the O-ring Removal Pick, remove O-ring.
2. Clean sand, salt, other contaminants and old grease from O-ring.
3. Clean O-ring Groove and O-ring Contact Surface using a clean cotton swab.
4. Visually and physically check O-ring by passing through finger tips, feeling for cuts,
cracks or any other defects. Such defects will cause water leakage, so be sure to replace
the O-ring. Be careful not to stretch or pull the O-rings too much.
5. Squeeze a rice grain sized bead of silicone grease on your thumb and forefinger. Taking
care not to pull or stretch the O-ring too much, uniformly spread grease on O-ring. Too
little grease may cause the O-ring to twist in the groove, possibly causing water leakage.
6. Place O-ring in the O-ring Groove, making sure that it is uniform, not twisted or bulging
out, possibly causing water leakage. When closing back cover, visually check O-ring
surface, tracing a finger over it to making sure no hair, lint or other contaminants are
attached.
IMPORTANT NOTES:
※
When housing is not used for long periods, remove O-ring and place in a plastic bags to
keep it free of dust and other contaminants and store in a place out of direct sunlight.
Please also be careful of prolonged exposure to direct sunlight during use. The O-ring
may become deformed, causing water leakage.
※
After extended periods of non-use, soak empty housing in lukewarm water for half a day.
Manipulate all buttons and dials several times. Using a soft, dry cloth wipe away water.
CAUTION!
※
O-ring are an essential part of waterproofing for this housing. Not properly greasing the O-
rings as directed may cause the O-ring to twist in the O-ring groove, possibly causing
water leakage.
※
Always perform the above O-ring, O-ring groove and O-ring Contact Surface maintenance
and greasing every time you open/close the housing.
※
Please pay close attention and make sure the O-ring are is twisted or bulging, free of any
contaminants (dirt, hair, etc.), and that foreign objects do not obstruct proper closing of the
housing Back Cover or attachment of the Lens Port.
※
DO NOT clean the housing with volatile organic solvents or chemical cleaning agents such
as thinner, gasoline, and benzine, etc.
SPECIFICATIONS
Compatible Camera CANON PowerShot G1 X Mark III
Maximum Depth 100 meters (328 feet)
Material Main Body, Back Cover, Port: Corrosion-resistant Aluminum
Alloy, Anodized
Lever, Buttons, Dials: POM, PC
Lens, Flash & LCD Window: Hard Coat Acrylic
Screws, Springs, Shafts: Stainless Steel, Galvanized
Dimensions
Weight
W153.3mm x D126.1mm x H108.5mm
Approx. 1.040Kg (Land w/Airlock Vacuum Valve)
Approx. 370g (Freshwater w/Camera)
Accessories M67 Adpater Diffuser, Strobe Mask-External Strobe Connection
Mount (Fiber-Optic/Sea&Sea), Wrist Strap, Reserve O-ring, O-
ring Removal Pick, O-ring Grease
8.