1. Using the O-ring Removal Pick, remove O-rings.
2. Clean sand, salt, other contaminants and old grease from O-rings.
3. Clean O-ring grooves and O-ring Contact Surfaces using a clean cotton swab.
4. Visually and physically check each O-rings by running it through finger tips, feeling for
cuts, cracks or any other defects that may cause leakage. Such defects will cause water
leakage, if found be sure to replace the O-ring. Be careful not to stretch or pull the O-ring
too much.
5. Squeeze a rice grain sized bead of silicone grease between your thumb and forefinger.
Taking care not to pull or stretch the O-rings too much, uniformly spread grease on O-
rings. Too little grease may cause the O-rings to twist in the groove, possibly causing
water leakage.
6. Place O-rings in the O-ring grooves, making sure they are uniform, not twisted or bulging
out, possibly causing water leakage. When closing back cover, visually check O-ring
Contact Surfaces, tracing a finger over it to making sure no hair, lint or other
contaminants are attached.
IMPORTANT NOTES:
※
When housing is not used for long periods, remove O-rings and place in separate plastic
bags to keep them free of dust and other contaminants and store in a place out of direct
sunlight. Please also be careful of prolonged exposure to direct sunlight during use. The
O-rings and housing may become deformed, causing water leakage.
※
After extended periods of non-use, soak closed empty housing with Lens Port attached in
lukewarm for half a day. Manipulate all buttons and dials several times. Using a soft, dry
cloth wipe away water.
CAUTION!
※
The O-ring is an essential part of waterproofing for this housing. Not properly greasing the
O-ring as directed may cause the O-ring to twist in the O-ring groove, possibly causing
water leakage.
※
Always perform the above O-ring, O-ring Groove and O-ring Contact Surface maintenance
and greasing every time you open/close the housing.
※
Please pay close attention and make sure the O-ring is not twisted or bulging, free of any
contaminants (dirt, hair, etc.), and that foreign objects do not obstruct proper closing of the
housing Back Cover.
※
DO NOT clean the housing with volatile organic solvents or chemical cleaning agents such
as thinner, gasoline, and benzine, etc.
※
Flash and Monitor windows are manufactured using hard coat acrylic. When cleaning use
a clean soft cloth taking care not to scratch them.
SPECIFICATIONS
Compatible Camera
OLYMPUS OM-D E-M1
Maximum Depth
100 meters (328 feet)
Material
Main Body and Back Cover:
Lever, Buttons, Dials:
Flash and Monitor Window:
Screws, Springs, Shafts:
Corrosion-resistant Aluminum Alloy, Anodized
POM, PC
Hard Coat Acrylic
Stainless Steel, Galvanized / SUS
Size (Housing)
Dimensions: W184mm x D95mm x H153mm
Weight: 1.440kg (Land / Housing only)
0.390kg (Freshwater / Housing w/Camera,
12-50mm Lens, Lens Port & Gear)
9.
