SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Configure System
Learning System >
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Configure System
Learning System >
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Configure System
Learning System >
SERVICE STG
Parameter >
Maintenance >
Functions >
Operation mode >
Configure System
Learning System >
Configure System
Door Type
Motor
Lock Type
Battery
20
>
>
>
Door Type
Basic Escape Route
Folding Door Austria
Folding Door USA
20
15
19
18
Breakout USA
14
CO 48 Sandow Direct
Configure System
Door Type
Motor
Lock Type
Battery
20
>
6
>
Press
“OK”
Press
“OK”
Motor
4 ATE21
5 ATE19 Small
6 ATE19 Large
7 ATE16 Normal
0 Without
3 ATE20
Lock Type
4 Bistable
5 MPV20
6 MPV16
7 Magnet
0 Without
3 Motor Powered
Configure System
Door Type
Motor
Lock Type
Battery
20
>
3
>
Configure System
Door Type
Motor
Lock Type
Battery
20
0
3
>
If Lock on-
board will need
set to (11)Fail-
Secure or
(12)Fail Safe.
Press OK
Configure System
Door Type
Motor
Lock Type
Battery
20
0
3
0
Battery
0 Without
1 Lead
Set to (1)Lead
if Lead Acid
Battery
onboard.
Press OK
SERVICE STG
Parameter
Maintenance >
Functions
Operation mode >
Configure System
Learning System >
>
Learning
running parameter
Yes
No
Please wait till the
door is open
ESC Cancel
Follow prompts for
door calibration,
typically 2 cycles &
screen “Learning
running param.
completed”.
Learning Sensors
select “No” & “Ok”.
At this point, retrieve the “Parameter Sheet” found in the plastic sleeve
attached to the inside of the removable cover to the unit. Proceed by
confirming that all the Settings in the “Plant” columns have been completed.
