17
11. Operation
Firmly hold the hand wheel and turn the face plate anti-clockwise to remove
as shown in
Fig 11.6
.
Insert the drive centre into the headstock spindle,
Fig 11.7
.
Removing the 4-Prong Drive Centre from the Headstock
The operating bar is used to remove the drive centre from the headstock
spindle. Place it into the hole positioned centrally in the hand wheel, at
the opposite side of the headstock from the drive centre and give the drive
centre a sharp knock to dislodge it,
Fig 11.8
.
It is advisable to hold the drive centre to eliminate the risk of it being ejected
with force and causing injury.
Fitting the Revolving Centre to the Tailstock
When turning between centres the revolving centre should be used in
conjunction with the 4-prong drive centre. For details on turning between
centres, please refer to the
Intended use of the Lathe and Basic
Woodturning Instructions
chapter of the manual.
Insert the revolving centre into the tailstock quill as shown in
Fig 11.9
.
To adjust the position of the quill use the hand wheel at the rear of the
tailstock,
Fig 11.10
. The quill can be locked in position using the quill
locking lever.
To remove the live centre from the tailstock turn the hand wheel anti-
clockwise until the quill pushes the live centre out as shown in
Fig 11.10
.
Fig 11.7
4-prong
drive centre
Fig 11.6
Fig 11.9
Quill locking lever
Fig 11.10
Fig 11.8
Operating
bar
Summary of Contents for Coronet Envoy
Page 37: ...37 ...
