Record Power BS400 Premium, Original Instruction Manual, Page: 13 / 36

13
4. Fitting Optional Wheel Kit, Transporting & Positioning
When moving and positioning this machine do not hold the table and drag
it, always hold the spine or lower wheel box,
see
Fig 4.6a and 4.6b
. If
moving long distances position the machine on a trolley before moving, see
Fig 4.6c .
Fig. 4.5a Fig. 4.5b Fig. 4.5c
4.4 Positioning the machine
The machine should not be located in a confined space. Ensure that the
working area is adequately lit. A cabinet located nearby is useful for the
safe and secure storage of tooIs, blades and accessories.
The machine should be located on a solid surface that is level. If the
machine is to be permanently located four mounting holes are provided in
the base so the machine can be bolted to the floor. Ensure that the anti-
corrosive coating is removed from the table and other working parts used
before use.
Fig. 4.6a Fig. 4.6b Fig. 4.6c
4.3 Moving the machine
Damage caused by incorrect handling, transportation or installation may
invalidate the guarantee. Consequently if in doubt about the safe handling
or installation of the machine obtain the services of a competent technician,
contact Record Power customer services, or contact the organisation from
which the machine was purchased.
When transporting this machine do not strap across the table or over the
top of the machines,
Fig 4.5a and 4.5b . Always locate retaining straps
over the lower wheel box beneath the table Fig. 4.5c.
4.1 Fitting the optional wheel kit
CAUTION! The machine is heavy. Additional help or a suitable
lifting device or support will be required for fitting wheels.
Fig. 4.1
Fig. 4.2
Jockey support bracket
Bolt
Fig. 4.3
Washers & split pin
Fig. 4.4
Jockey bar
Hexagon bolts & split pin
i
Kg
i
Kg
The jockey support bracket is held in place by 2 bolts. The jockey support
bracket also levels the machine after the rear wheels have been fitted.
• First lift up the front (table end) of the machine with a suitable lifting
device. Do not lift the machine using the table. Now fit the jockey support
bracket to the base, bolt the bracket through the pre-drilled hole at either
end of the base and fully tighten,
Fig.4.2 .
• Again using a suitable support, lift the rear (spine end) of the machine up
and slide the axle through the base. Fit a wheel to either end of the axle and
secure them with a washer each side of the wheel and split pin,
Fig.4.3
.
4.2 Using The Jacking Bar
The wheel kit is now fitted. Attach the wheels to the jockey bar using
the hexagon bolts and split pin, this jacking bar is now used to lift and
manoeuvre the front of the machine,
Fig.4.4 .
CAUTION! This wheel kit is only to be used on a level surface.
Contents of the packages
1. Jockey support bracket
2. Axle
3. 4 x split pins and washer
4. 4 x wheels
5. 2 x nuts, bolts and washers
6. Jockey bar
1
2 6
4
3 5