©2016 ReconRobotics
7
Instructions for Use: Chargers
Instructions for Use: Chargers
Reading Charge Indicator Lights on Battery Chargers
Your kit may include one or both of these chargers. When plugged into an active
power source, the indicator LEDs will display the following charge states:
*Battery not included.
AC Dual DC Battery
Charger
BA5590/BB2590 Field
Charger*
Green
Light
Fully charged
OR
Not plugged into OCU II/
robot
Fully charged
NOTE: LED light may shut off
after charging is complete
Red Light
Charging
Charging
No Light
Not receiving power from
outlet
Not plugged into OCU II/robot
OR
Charging is complete (fully
charged)
Blinking
Light
Charger is connected incor-
rectly and is not charging the
robot/OCU II. Unplug eve-
rything and retry (refer to
page 8 for instructions).
N/A
©2016 ReconRobotics
8
AC Dual DC Battery Charger
1. Turn off OCU II and insert activation pin into robot to deactivate before charging.
2. Plug AC electrical cord into the charger. (NOTE: charger
must
be connected to a
power source before robot or OCU II for proper operation)
3. Plug AC electrical cord into the proper country-specific AC wall socket (120-240
VAC).
4. Plug the appropriate charger cords into the OCU II and robot. Ensure connecting
plugs are not bent during insertion or removal. Ensure that the red dot on the
connecting plug is aligned with the red line on the robot when inserting (see image
at right).
5. Remove robot and OCU II from charger when charging is complete.
BA5590/BB2590 Field Charger
1. Turn off OCU II and insert activation pin into robot to deactivate before charging.
2. Plug electrical cord into a 5590 or 2590 battery.
3. Plug the appropriate charger cords into the OCU II and robot. Ensure connecting
plugs are not bent during insertion or removal. Ensure that the red dot on the
connecting plug is aligned with the red dot on the robot when inserting (see image
above).
4. Remove robot and OCU II from charger when charging is complete.
General Instructions & Recommendations
Place the chargers in a cool, ventilated, fire-safe area.
Charge your robot and OCU II once per month, even if they were not used. This
will keep the batteries topped off to ensure the robot is always ready for immediate
deployment.
To prevent battery damage, DO NOT
use any chargers other than those
supplied by ReconRobotics.
The charger plugs are NOT interchangeable.
Inserting the wrong plug into the robot or OCU II
could result in permanent damage.
