UL AND IEC INSTALLATION GUIDE
p.
4 of 14
Installation Instructions UL-1703 and IEC
/ Rev. 05-2018 V.5
RECOM © Copyright 2018
www.recom-solar.com
• When installing the system, abide to all local, regional and national statutory regulations. Obtain a building
permit if necessary.
• Under standard test conditions, the electrical characteristics are within ±5 percent of the indicated values of
Isc and Voc (irradiance of 100mW/cm², AM 1.5 spectrum, cell temperature 25°C (77°F)).
• Only use equipment, connectors, wiring and support frames suitable for solar electric systems.
2. STORAGE, UNPACKING AND HANDLING
• Packaged modules must be stored indoors; in a dry and ventilated area.
• Once opened, continue to store modules in a dry and ventilated room.
• Do not expose packaged modules to rain, snow, hail or other environmental conditions that will compromise
the modules or packaging.
• To safely keep modules stored, they must remain packaged on the provided pallets, and must not be stacked
more than two pallets high.
• Modules should never be stored in a wet or outdoor environment.
• Upon unpacking, only carry a module by its frame with two or more people. Do not carry a module by the
wires or junction box.
• Keep all electrical components clean and dry.
• All modules are manufactured with a sealed junction box, pre-attached cables and locking connectors.
These components should not be modified or tampered with in any way.
• Do not allow unauthorized persons near the installation site or module storage area.
• Do not place or drop objects on top of the modules, including another module.
• Do not place any load on the module.
• Do not twist the module frame.
• Do not stand, step, walk or jump on the module.
• Do not handle modules with bare hands; avoid scratching, handling marks or any other damage, especially
to the front glass, back sheet or electrical components.
• Do not mark the modules with sharp instruments.
• Do not leave a module unsupported or unsecured.
• Do not modify module frames in any way.
