POWERSPORTS CAN SPEAKERS
R65
SPECIFICATIONS:
INSTALLATION CONSIDERATIONS:
MODEL
R65
Passive Radiator:
Power Rating:
Sensitivity:
MidBass:
Tweeter:
Nominal Impedance:
Mounting Dimensions (enclosure):
Length:
Width:
Height:
SPECIFICATIONS
4"(102mm)
160WMAX/80WRMS
85 dB @ 1W/1M
6.5"(165mm) Water-Proof Speaker
1"(25.4 mm) PEI Tweeter
4 ohm
8.27"(209.8mm)
6.89"(175mm)
9.91"(251.8mm)
TYPE
6.5" Can Speaker
1. Be sure to carefully read and understand the instructions before attempting to
install these speakers.
2. For safety, disconnect the negative battery terminal from the battery prior to
beginning the installation.
3. For easier assembly, we suggest you have all your tools handy: drill, Allen
wrench set, crimps, soldering iron, wire strippers, heat -shrink, etc.
4. Use high quality, waterproof connectors for a reliable installation and to mini-
mize signal or power loss.
5. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake
or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.
If installing in a boat, take care not to cut or drill through the main hull.
б
. lf possible, do not run wires near fuel lines or power. Running the wires inside the
hull area provides the best protection.
7. Avoid running wires over or through sharp edges. Use rubber of plastic gromets
to protect any wires routed through metal — especially the tower.
8. Make sure the mounting clamps are tight before leaving the dock or cruising
off-road.
