HandPunch 2000 Installation and Operations Manual
23
Maintenance
To maintain optimum performance, inspect and clean the hand reader
regularly. Clean
the platen, side mirror and reflector, and the window above the platen using a cloth
dampened with ordinary window cleaner.
DO NOT SPRAY CLEANING FLUID
DIRECTLY INTO OR ON THE HAND READER.
Check users’ scores (shown on
the LCD display when they verify). Scores should average under 30. Occasionally a
user will score above 30. This is not an indication of poor performance. If scores
average over 30, clean the reader and check again. If scores remain high, or if users are
experiencing frequent rejections, run the
CALIBRATION mode. By setting STATUS, you can view the last employee’s score
and the status of the tamper switch.
Memory reset
The memory-reset dip switches (4 and 5) are factory set in the “off” position. The reader
maintains setup and user memory in the event of power failure. To the reset the setup
programs to factory default without erasing the user database, switch 4 on, remove and
reapply power. To erase the user memory and reset the setup programs to factory
default (total reset), set switches 4 and 5 on, remove and reapply power.
