Beijing Reci Laser Technology Co., Ltd
User Guide for FCA Series Hand Laser Welding System
25
Chapter 5 Use of monitoring software
The monitoring software for FCA series Fiber Laser, even the followed products of the same
series is the same.
5.1
Connect
Use the RS485 cable of the device to connect the 1st & the 2nd pin of Rear panel's
CTRL-INTERFACE. The 1st pin connects to the T/R+ port of the wire, the 2nd pin connects to the
T/R- port of the wire.
Figure 5.1 The connection of RS485 interface
Then connect the other side of 485 wire to the PC which is installed the software.
Open the software. Click to Setting page
（
as the figure 5.2
），
Select the corresponding serial
Num
，
Click “open port” button. After choosing the right one
，
Click “set default ”button
，
The next
time the software starts, it will automatically open the serial port.
Figure 5.2 Setting of serial port
1
2
3
