ReChargX
™
RX160
8am - 8pm ET Mon - Fri
© 1995-2014 ReChargX, EmptyX, TonerRefillKits, TonerRefillKits.com, the TonerRefillKits logo, the
V4.0 - 2014.04.22
800.527.3712 or 352.343.7533
ReChargX and EmptyX logos are trademarks owned by TonerRefillkits.com, LLC. All rights reserved.
Page 4 of 10
Step 7: Remove the toner hopper plug
Using the cartridge body as a fulcrum, wedge the
edge of the flat-blade screwdriver between the lip
of the cartridge and the toner hopper plug, then
proceed to pry the plug up and out (figure 7-1).
Note:
Don’t worry about damaging the plug. We
have included a replacement plug in the ReChargX™
RX160 toner refill kit.
Step 8: Remove the remaining Brother toner
Prior to adding “fresh” toner, we must remove the
residual “old” toner.
On the first refill of your Brother toner cartridge, the
new toner should not be combined with whatever
quantity of Brother toner that remains in the hopper.
Failure to remove the remaining Brother toner will
result in splotching, smudging, hazing and other
print defects.
Note
: This step does not need to be performed on
subsequent refills when fresh ReChargX
™
toner is
being added to existing ReChargX
™
toner.
Insert the toner hopper opening end of the cartridge
into the plastic zip-top bag which is included in the
ReChargX
™
RX160 toner refill kit (figure 8-1).
Carefully pour out as much of the residual toner as
possible (tapping along the side of the cartridge helps
to keep the toner flowing).
If the toner stops flowing, stand the cartridge upright
(with the toner hopper fill hole facing up) and then put
the end of the cartridge back into the bag and
continue the emptying process.
With the majority of the toner removed, remove the
cartridge from the bag. Seal the bag and discard it.
Figure 7-1:
Removing the toner hopper plug
Figure 8-1:
Inserting the cartridge into the plastic bag and
removing the remaining Brother toner
