Rears Pakblast 50 Gal, Manual, Page: 25 / 58

7
Pak-Blast
50 gallon
Read this manual completely before operating: follow all safety instructions.
x
Your PTO driveline
Compare your measurement
x
with the chart, below.
The driveline that ships with your sprayer will accomo-
date a wide range of tractor models.
Before operating, install the driveline and check lift-arms
range of travel:
measure driveline length where the
expansion is greatest.
The maximum driveline expansion is provided in the
chart,
below . Measure the
cross to cross
distance as
illustrated by
z
, right . If the measured expansion of
the installed driveline is close to or over this maximum
length call your dealer to order a longer driveline.
For long drive-component life,
operate the PTO with the
tractor PTO shaft and the pump drive shaft in-line: the
implement drive-line should be level.
To simplify hook-up and disconnect procedures, store the
Pak-Blast on a stable, raised platform.
Measure distance
x
between the
end of your tractor PTO shaft and
the center of the lift arm ball
sockets. The ball sockets must be
level with the PTO shaft: slide a
broom handle through the ball
sockets to aid measurement.
x
side view top view
cross to cross
whole driveline halves
a
yoke & shaft assembly
end yokes
c
driveline shields
d
z
male half
female half, implement end
Driveline part numbers
whole driveline
compressed
maximum
cross -
shaft end
cross kit
22” & UNDER DL201 24”OAL 15
1
/
8
”
22
1
/
8
”
female
1.375” 6 spline
DL213 11
3
/
4
”
Y201 DLS201M CPL14N
male
1.375” 6 spline
DL211 13
3
/
8
”
Y201 DLS201F CPL14N
OVER 22” CALL DEALER
z
x a
d
c