Rear View Safety
Reverse With Confidence
™
6
7
Radar Sensor Detection Range
Antenna Beam angle
Horizontal : 80
°
(-3dB)
Vertical : 10
°
(-3dB)
Detection time : < 100ms
Radar Sensor Detection Range
Antenna Beam angle
Horizontal : 80
°
(-3dB)
Vertical : 10
°
(-3dB)
Detection time : < 100ms
RAD
AR SENSOR DETEC
TION R
ANGE
CHANGING DETEC
TION MODES
Changing Detection Modes
The installation site should be flat. Ideally the radar sensor should be mounted on the rear of the
vehicle as close to the center as possible at roughly 1 meter above the ground. The sensor should
be mounted in the upright position with the cable exit on the sensor pointing downwards.
Sensor Mounting
Mounting Angle
Select the appropriate location to mount the sensor.
a. Height range (from ground); 1m +/- 0.3 m)
b. Vertical angle range +5 (up), -2° (down)
c. Horizontal angle range +/- 5
System Description
III
●
The
Radar
Object
Detection
System
uses
FMCW
(frequency
modulated
continuous
wave)
radar
technology
to
detect
stationary
objects
and
people
in
blind
spots.
●
This
advanced
system
alerts
the
operator
with
both
visual
and
audible
warnings.
●
The
system
has
three
distinct
length
and
width
modes
, enabling the operator to adjust the
system
to
fit
their
needs.
●
The
commercial
grade
heavy-duty
system
has
an
IP69K
waterproof
ratin
g and works
perfectly
in
all
weather
conditions.
Installation
IV
Sensor Mounting
The installation site should be flat. Ideally the radar sensor should be mounted
on the rear of the
vehicles as close to the center as possible at roughly 1 meter above the ground.
The sensor should be mounted in the upright position with cable exit on the sensor pointing downwards.
Mounting angle
Select the appropriate location to mount the sensor.
a. Height tolerance (from ground); 1m +/- 0.3 m)
b. Vertical angle tol5 (up), -2° (down)
c. Horizontal angle tol/- 5
Note:
Before permanently installing the RODS(Radar object detection sensor) on the vehicle, verify that the
selected sensor mounting location provides a clear detection zone.
Take the machine to a clear area, temporarily attach the sensor in the proposed mounting location,
apply power to the system, and verify that nothing is being detected.
Our system is not affected if multiple systems are operating in the same area or on the same vehicle,
even if they are installed in close proximity with overlapping detection ranges.
There is no detection of objection or part of an object closer than approx. 0.3m to the sensor.
-5°
+5°
-2°
+5°
3
1. Long press “Dim” and “Vol” together to adjust mode (LED will flash 3 times).
2. Press “Dim” to toggle Mode 1 ~ Mode 3.
Mode 1: 3.5 x 4.0 (L) meter (3 zones)
Mode 2: 5.8 x 6.8 (L) meter (5 zones)
Mode 3: 7.0 x 8.0 (L) meter (5 zones)
3. Press “Vol” to save desired mode.
Button Explanation
1. Dim Button: Press “Dim” to adjust LED (3 steps)
2. Volume button: Press “Vol” to adjust volume
3. Factory Reset: Press “Dim” button before turning system on. LED 1 ~ 3 will flash sequentially.
Antenna Radiation Pattern
