9
Reverse With Confidence
™
Installation Guide
Camera
1. Attach camera bracket close to rear marker lights, centered
on vehicle (Figure 1.5 number 5).
2. Attach camera to bracket using screws provided and adjust
the angle.
Cable + Quick Connect/Disconnect Kit
1. The cable on this system is split into three parts, two camera
cables that end with Quick Connect terminals and a Pigtail Cable.
2. The first camera cable (26') mounts on the tow vehicle. It runs
from the cab to the back of the tow vehicle where it is mounted
flush to the vehicle (Figure 1.5 number 2).
3. The second cable (66') mounts on the trailer. It runs from the
camera on the back of the trailer up to the front of the trailer
where it is mounted flush to the vehicle (Figure 1.5 number 3).
4. To complete the connection, just connect the Pigtail Cable to
both terminals and the circuit is complete (Figure 1.5 number 4).
Monitor
1. To Attach the Pedestal mount to the dashboard or
to the headliner using self-tapping screws and/or
adhesive pad.
2. Attach monitor to mount, and adjust mounting angle to allow
optimum driver viewing comfort. (see figure 1.1 on page 12)
Tip: Start wiring from the end with the quick connect bracket. In
other words, first install the quick connect bracket and then run
the cabling through the truck or the trailer.
Summary of Contents for 1/3" Sharp Color CCD
Page 1: ...1 TM ...
Page 16: ...REAR VIEW SAFETY 16 Positioning ...
Page 20: ...REAR VIEW SAFETY 20 Camera Dimensions 3 3 25 ...
