■
Remove the plug from the socket after use.
■
Turn the thermostat to ZERO (0) and slide the power switch to the off position to turn off the unit.
Switching off
■
Place the device on a heat-resistant and level surface.
■
Only connect the device to a properly installed safety socket
■
If it is not used for a long time, clean it up first, then pack it into the packing box, store it in a flat and dry place, and do not apply
pressure on it.
■
If the surface is dirty, it can be wiped with a soft cloth stained with detergent. Chemical solvents such as gasoline and toluene are
not allowed. Do not wash in water.
■
Check and clean the components frequently to avoid burning, smoking and danger.
■
Please cut off the power supply before maintenance
Maintenance
■
Do not dry clothes and other articles, do not cover them, stay away from inflammable and explosive articles when used.
■
Animals are not allowed to warm, and the elderly, children and people who cannot take care of themselves are not allowed to use
Warnings
3. III 2500W
Technical Information
Power Rating: 2500W
3. I 1000W
3. II 1500W
Position the wheel base assembles between the end fins.
1. Remove the heater and all the accessories from the carton.
Assembly
Commissioning
■
The distance from the air outlet grille to the nearest wall should be at least 0,9 m.
Keep all safety instructions and instructions for future reference.
■
Do not use this heater in the bathroom, near the shower head or around the swimming pool.
Turn the heater upside down.
Operation
2. The desired room temperature is set here.
The radiator offers 3 heating levels:
The control lamp lights up when the device is heating up.
Attach them to the heater using the U-bolls and wing nuts supplied.
Tighten the wing nuts.
Turn the heater the right way up.
Overheating Protection
■
Should the overheating protection shut the device off again shortly after, there is probably a defect. Switch off the device again and
pull out the plug.
The device is equipped with an overheating protection that switches the device automatically off in case of overheating.
■
Turn the two circuit breakers to the lowest setting and unplug the power cord from the outlet. Allow the device to cool down for
about 10 minutes before using it again.
■
Check if the air inlet or outlet of the heater is blocked. If this is the case, the blockage should be removed.
