36
Page
C O N V E R S I O N D E TA I L S / I N J E C T O R – P I LO T A N D B U R N E R
R E M O VA L
Natural gas / Propane
1. Turn appliance off and allow to cool.
2. Turn gas supply off.
3. Turn off and isolate electrical supply from appliance
4. Remove lower trim angle (lift upwards).
5. Remove trim – slide down and out.
6. Remove door bolts - hinge door slightly forward
and lift up. NOTE – recommended 2 persons
required to remove door,
7. Remove media from burner if fitted. Dust mask
recommended to be worn.
8. Remove burner media tray.
9. Remove pilot bracket holding screws.
10. Remove screws holding burner to base plate (at both
ends of burner).
11. Lift burner up gently and support.(REFER FURTHER
DETAILED INSTRUCTIONS BELOW)
12. Undo gas pipe connection at end of burner. (15mm
and 16mm spanner required). Burner can now
be lifted out.
13. Lift burner out gently.
Keep burner in the flat position until insulation is restrained
(Rotating the burner may cause insulation to fall and be
damaged.
RECOMMENDED STEP
To avoid damage to the insulation apply low tack tape
to the burner to restrain the insulation into position. Avoid
pressing the tape onto the media. The insulation media
may easily crack if the appliance has been operated for
several hours. The media may be carefully lifted out and
placed flat to store until refitting.
14. The media can be repainted using an approved high
temperature paint, contact Glen Dimplex for details
15. Undo pilot bracket screws, lift up gently.
16. Undo pilot gas pipe.
17. Remove spark lead
18. Remove spark sensor probe
19. Remove pilot assembly from firebox.
20. Replace pilot assy with correct gas type.
21. Replace pilot orifice with correct gas type
22. Refit pilot gas tube, tighten all fittings.
23. Refit spark lead
24. Refit flame sensor
25. Screw pilot assembly to firebox base.
26. Ensure pilot wire holes are sealed at base of firebox,
where not sealed a high temp silicon should be used
around the wires.
27. Check all wires are sitting correctly, flush to
front wall. Ensure spark lead is not broken or
excessively bent. Ensure lead hole is still sealed.
(High temperature silicon is suitable for resealing.)
