13
2. Remove the water bucket from the base unit and fill with
clean (fresh)water . (Fig 15)
WARNING!
The intake water temperature must not
exceed 104
°
F/40
°
C .
CAUTION!
The washer must only be used with
clean (fresh) water; use of unfiltered water containing
corrosive chemicals will damage the water.
WARNING!
Do not fill the bucket with the bucket
still fixed on the base unit.
3. Put the bucket back on the base unit. Make sure the bucket
is properly aligned on the base. Latch and lock the bucket
to ensure the bucket is securely connected before using.(Fig.
3-4).
NOTE:
If you do not want to use the bucket, you can use
the base unit directly as a pressure washer. See following
instructions (step 4-5) to learn how to connect the base unit
with a water supply .
4. Connect the garden hose adapter (female couple) to the
water inlet of the pressure washer on the base unit, then
thread your garden hose (male end )into the garden hose
adapter(Flg 16).The garden hose must have an internal
diameter of at least 13mm(1/2in.)and must be reinforced.
The water supply must be at least equal to the washer
delivery capacity.
5. Attach garden hose to water supply (Fig.17).
WARNING!
Water that has flowed through back
flow preventer is considered to be non-potable.
WARNING!
The water supply must not exceed
0.7Mpa.
6. If only using the base unit, turn the water supply tap
on the completely.
7. Push the safety lock on the spray gun handle,then
press the trigger for a few seconds until the water
flow is steady. Operating the pressure washer in this
manner will allow air to escape and discharge
residual pressure in the hose (Fig. 18).
8. Keep the trigger pressed, turn on the unit by turn the
On/Off knob on the machine. Choose high or low
pressure as showing. (Fig 19).
