w w w .ReadyLI FT.com - Phone: ( 800) 549-4620
I nstallation I nstructions 66- 2215
7
7-11-16 MMC
***Final install and checks***
Recheck that all hardware is of proper torque values and all electrical connections are
hooked up. Start vehicle and verify that all dash warning lights are off. Cycle the steering
wheel from lock to lock to check for any interference of steering intermediate shaft, steering
extension, steering u-joint. wheels, tires, brake lines, hoses, wires, ect and ensure adequate
clearance through out the suspension cycle. Adjust as necessary.
Install all warning tags and decals as directed:
1. Rear view mirror hanging warning card: Hang from rear view mirror to warn driver of vehi-
cle modification.
2. Lifted truck warning decal: Apply decal to the upper left hand corner of the inside of the
windshield facing the driver.
Give all installation instructions, warranty information, and all remaining literature to
the end user to keep with vehicle records.
Torque the upper ball joint nut to
85 ft-lbs.
Tighten the upper strut mounting hardware. Torque to
30 ft-lbs.
Install the tie rod end to the knuckle using
factory hardware
. Torque to
110 ft-lbs.
Install all brake line brackets and ABS lines to the knuckle and frame using
factory hardware
.
Torque to
5 ft-lbs.
Install the wheels and lower the vehicle to the ground. Torque the lug nuts to the manufactures
specifications.
Jounce the front suspension to get the vehicle to settle to ride height. Torque the upper and
lower control arm to
120 ft-lbs
.
Have the alignment set to the provided specs on the last page by a reputable alignment shop.
