w w w .ReadyLI FT.com - Phone: ( 800) 549-4620
I nstallation I nstructions 66- 2215
4
7-11-16 MMC
Park vehicle on a clean flat surface and block the rear wheels for
safety. Engage the parking brake.
Record the stock vehicle measurements on both the front and the
rear, this will provide a guideline on vehicle rake and lift height.
Measure from the center of the wheel up to the bottom edge of the
fender well opening and record on the chart provided on page 2.
Disconnect the vehicle power source at the ground terminal on the
battery.
Lock the steering wheel in the straight forward position with the col-
umn lock or steering wheel locking device.
Raise the front of the vehicle and support with jack stands at each
frame rail behind the lower control arms.
***2011 and newer models equipped with EPAS (Electronic Power
Assist Steering), disconnect the power steering control module to
avoid arching of the contacts in the internal power relay from a ham-
mer blow or impact wrench.***
Raise the front of the vehicle and support with jack stands at each
frame rail behind the lower control arms.
Remove the front wheels.
(Fig 1)
Disconnect the ABS connectors in the engine compartment. Driver
side is by the air box and the passenger side is next to the battery.
(Fig 2, 3)
Remove the brake line brackets and ABS wires from the knuckle and
frame. Make sure to hang ABS wire out of the way in a safe location
so as not to damage the wire when removing the strut.
(Fig 4, 5)
Disconnect vacuum line from the vacuum actuator.
(Fig 6)
FIG 1
FIG 2
FIG 3
FIG 4
FIG 5
FIG 6
