If the controller doesn't connect, make sure your computer is connected to the
Service port (X2) on the IRC5. Then, make sure that your computer's Ethernet port
settings have DHCP enabled. For help setting up your computer network
connection, see Windows help on TCP/IP settings.
2
Backup the controller (skip this step if you already saved a backup).
In the RobotStudio
Controller
tab, click the
Backup
dropdown and select
Create
Backup
.
1
Choose where to save your backup, then click
OK
to start the backup and wait for it
to finish.
2
6
Set the mode switch on the ABB controller to AUTO, then in the
Controller
tab click
Request Write Access
. This allows you to edit settings on the controller.
7
Reset the controller to its factory default settings.
Note:
The rest of this guide assumes the ABB controller is set to factory settings. If you
don't factory reset the system, you might experience errors because of conflicting
settings.
8
VERSION 1.0.0
© 2021 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
25