Instruction manual
Page 56 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
Stripper plate with shortened outlet and shortened inlet (51 mm):
This stripper plate has an outlet side that is shortened exactly as described in the previous section.
In addition, this model is characterized by an extremely shortened inlet side. The total length is now
only 51 mm. Here this stripper plate is highly suitable for extreme narrow spaces. As the product is
no longer guided into the inlet side, this stripper plate may only be used in applications that can
ensure the precise and fixed guidance of the product to be printed. An additional positioning wheel
cannot be mounted to this version!
Figure 45: Scope of delivery of the single stripper plate, extreme short constructional design (51mm)
Figure 46: REA JET HR print head with mounted single stripper plate, extreme short constructional design
This model is put to particular use in systems such as friction
feeders. Here, the assembly site is often very constricted due to
guide shafts. To allow for the constructional space gained through
the extremely shortened inlet to be used, REA JET offers a sensor
assembly plate for the rear offset installation of sensors for these
applications (054.830.501). Also refer to 3.2.2.3.3.
