Instruction manual
Page 61 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
Step 1:
Figure 55: Fastening the sensor to the assembly bracket
Step 2:
Figure 56: Fastening of the sensor with the assembly bracket to the print head
Step 3:
Figure 57: Fastening the cable to the assembly bracket
Controls
Screw the sensor (located beneath the assembly bracket)
with the two long screws
(A)
.
Direction:
Please ensure that depending on the desired assembly
position (right or left on the print head), the
controls/display elements of the sensor point upward and
that they are well accessible after installing the print head.
Screw retainer sheet incl. sensor to the print head with the
two short screws (
B
).
Attention
Only use the short screws (B) to
fasten the assembly bracket to the
print head. Longer screws would
extend into the interior of the print
head and make it difficult to insert
the cartridge or damage one that
has already been inserted.
Fasten the connection cable of the sensor to the retainer
sheet with the included cable tie. The cable must be
guided along the top of the angle bracket.
The fixation of the cable is particularly
important if the print head is mounted very
close to a conveyor belt or the like. As a
result, the cable cannot hang downward
and the transport mechanism protects it
against damage.
