Instruction manual
Page 101 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
3.2.6 Installation of the I/O multiplier
The I/O multiplier is used for the simultaneous connection of several components (e.g. a signal
lamp and a product sensor) to the I/O connection of a REA JET HR
pro
2K/4K.
Figure 123: Scope of delivery of the I/O multiplier
3.2.6.1 Installation on a 35 mm supporting rail
I
) Insert the holding element with the groove at the upper side into the supporting rail.
II
) Then press the housing on the lower side against the supporting rail until the mount has
snapped into place in the supporting rail.
Figure 124: Back and front view of the I/O multiplier, mounted to a 35mm supporting rail
3.2.6.2 Dismounting from a 35 mm supporting rail
I
) Place the tip of a suitable screwdriver into the lower flap of the mount.
II
) Carefully press the screwdriver against the housing to use the leverage to undo the lock.
Figure 125: Use of the screwdriver
Figure 126: Unlock the mount
This module is executed in protection class IP65.
The housing is intended for the following two
assembly types:
-- Assembly on a DIN 35 mm supporting rail.
-- Direct connection to the machine or system.
In the delivery state, the module has been prepared
for assembly to a 35 mm supporting rail.
I
II
II
I
