re3D gigabot, Quick Start Manual, Page: 14 / 34

quick start guide
14
b3
b4
These need to be loose
enough so that the ends
of the rails can move
vertically in the slots of
the side plates with little
to no resistance.
Adjust the leveling knobs
until there is about a 1/8”
gap (3mm) between the
top of the rail and the top
of the side plate at each
corner. A ruler or a shim
can be used to measure
this distance. Similarly,
users can opt to turn the
leveling knob to push the
rail up until it is flush with
the side plate, and then
lower it 4 full revolutions.