M0879.docx
| Rev 1.6 | Modified on 11/01/2018 | © Remote Control Technologies Pty Ltd
7 | 12
INSTALLATION GUIDE
WARNING!
A RELAY IS REQUIRED IN THIS SYSTEM AS A FAIL TO SAFE CIRCUIT. FAILURE
TO INCLUDE A RELAY IN THE CIRCUIT MAY RESULT IN DAMAGE TO THE
ENGINE AND/OR COMPONENTS.
1. Install the control unit, relay and bypass switch in a suitable location, preferably in the cabin.
2. Refer to the wiring table below and the wiring diagram in this manual to connect the controller. It is
recommended that the wiring is installed alongside the OEM wiring ensuring that it is secured at regular
intervals; this will provide protection from heat and abrasion, and any other excess damage that may occur
with extended vehicle operation. When securing the wiring to the OEM wiring, ensure that the loom is
away from moving vehicle parts which could lead to loom damage.
3. Mount the LED in a suitable location that is visible to the operator.
4. Remove the engine start/crank wire from the ignition switch and connect it to terminal 87 of the relay.
5. Connect the yellow wire (pin 8) to terminal 30 of the relay, run a second wire from the engine start/crank
terminal of the ignition switch and connect the other end to terminal 30 of the relay. There should now be
two wires connected to terminal 30 of the relay.
6. Connect the yellow/blue wire (pin 3) to terminal 86 of the relay.
Note:
It is recommended that a suppression diode be fitted across all inductive loads
WIRING CONNECTIONS
NO.
COLOUR
FUNCTION
DESCRIPTION
1
Red
IgVE
Connect to the permanent battery supply at the key switch
(supply 12-24 V DC).
2
Black
Ground
Earth (ground).
3
Yellow/Blue
Output 1
(ignition output)
Engine start/crank output (10 A continuous output).
4
Green
Output 3
Not used.
5
White
Input 1
Not used.
6
Orange
Input 3
Bypass key.
7
Pink
Input 4
Not used.
8
Yellow
Input 2
Engine start/crank input.
9
Blue
Output 4
Not used.
10
Purple
Output 2
Positive terminal of overcrank warning LED
11
Black/white
- VE
Ground terminal of overcrank warning LED
12
Red/white
BVE
Not used.
