4. Starting to Operate
Determining the IP or MAC address
To find out the IP address, you will need to press the bottom button 3 times in succession (press 4
times for the MAC address. Before pressing the next time, you will need to wait for a reaction
to the previous press).
When you press the first time, a running message regarding the electric current level (for example
«10Amps») will be displayed. Only numerical figures will be displayed after 5 seconds.
When you press the second time, the power level will be displayed also as a running message. Only
numerical figures will be displayed after 5 seconds.
When you press the third time, RPCM will switch over to IP address display mode.
When you press the fourth time, the MAC address will be displayed.
Receiving an IP address
IP address is obtained by default via DHCP. If there is no DHCP server or it is temporarily
unavailable, RPCM will obtain IP through Automatic Private IP Addressing (APIPA) thanks to Zero
Configuration.
When this method of configuring network addresses is used, IP ranging from 169.254.xxx.xxx,
Netmask 255.255.0.0 (CIDR standard — 169.254.0.0/16) are automatically assigned.
4
14
15
Fig. 7. The difference of elements on the front panel of RPCM ME 1563 (63A — Mining Edition)
Fig. 8. The difference of elements on the rear panel
of RPCM ME 1563 (63A — Mining Edition)
To reset the device, hold the top button on the front panel for 20 seconds.
Reset to Factory Settings