
DUAL PICKPOINT OPERATION
With “Dual pickpoint operation” the vertical
aiming of the array is set by trimming the hoist
motors after the array has been fully assembled
and lifted to its operating position.
PREPARATION OF THE FLYBAR
Place the flybar and remove the side pins from the transport
position. The front bracket will rotate, so lock it. Fix the front
brackets in vertical position locking the pins in position 2.
Recheck the Locking pin is securely locked by briefly pulling the
Locking pin towards you.
SINGLE PICKPOINT OPERATION
(suggested for 8 modules maximum)
Fit the pickup in the proper position number, (suggested by HDL
50-A Shape Designer), and fix the pickup bracket with the two
pins. The position of the pickup defines the vertical aiming of
the entire array.
Check that all the pins are secured and locked
PICK UP POINT POSITIONING
The pickup is asymmetric and can be fit in two positions (A and
B). A position brings the shackle towards the front. B position
allows an intermediate step using the same fixing holes.
Fix the pickup bracket with the two pins on the bracket’s
lanyard to lock the pickup.
Summary of Contents for HDL 50-A
Page 1: ...OWNER MANUAL ACTIVE THREE WAY LINE ARRAY MODULE HDL 50 A...
Page 10: ......