3. Mounting sequence
Product’s basic mounting location is located at the upper part of the
center of the vehicle’s front mirror. This location is the front part of the
room mirror in the case of the passenger car. Attach the part with the
tape attached onto the mirror, and adjust the angle so that it becomes
perpendicular to the ground surface to complete the mounting.
Step 1) Take out the cover of the two-sided tape attached on the main
body.
Step 2) Place the main body at the vehicle’s center.
Step 3) Press button front/rear angle so that the main body mounted on
the front glass to be right angle.
Step 4) When adjustment is completed, release the button to check if it is
Step 5) Connect power with power cable.
Step 6) Connect External Switch. It is possible to use External Switch to save
Event Data on emergency. Attach External Switch on the desired
location.
Step 7) When Beep Beep Beep (short sound) sounds after connecting
power, POWER, SD-CARD and GPS LEDs turn on for 20 seconds and
SD Card LED blinks, mounting is normally completed. GPS LED may
blinks for the time being according to ambient situation.
Please be care about Room Mirror.
Insta
ll
a
tio
n
g
uid
e
