Installation Instructions
14
A5.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE:
If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE:
We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE:
When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1–3. Do not pinch cord
or lift oven by pulling cord.
3.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least
two full turns
after the
threads have engaged. (It will be completely
tightened later.)
Be sure to keep power cord
tight. Be careful not to pinch the cord,
especially when mounting flush to bottom of
cabinet.
2.
Rotate front of oven
up against cabinet
bottom
1.
Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
A4.
CHECK FOR PROPER DAMPER
OPERATION
• Place the microwave in its upright position, with
the top of the unit facing up.
• This microwave oven may be shipped assembled
for top exhaust (adaptor installed) or for
recirculation exhaust (adaptor absent).
• Make sure tape securing damper is removed
and damper pivots easily before mounting
microwave.
• You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the microwave is installed.
Exhaust Adaptor
(absent on models
shipped for recirculation
exhaust)
Back of
Microwave
Damper
Blower Plate
