Powering Your Camcorder
14
Lithium Cell Installation
The remote’s lithium cell is packed separately. Install it as follows:
1. Turn remote over, insert a pencil or
paper clip in the small hole, and slide
cell holder in the direction of the
arrow to remove it.
2. Insert the cell in the cell holder so the
positive (+) terminal faces up.
Cell Holder
Insert Pencil Here
3. Replace cell holder in remote until it
clicks into place.
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace cell when camcorder fails to respond
to remote.
Remove cell from remote if it will not be used
for a month or more. This will prevent
possible damage from cell leakage.
If leakage occurs, wipe up liquid inside
compartment and replace cell.
Cautions: Lithium cell. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell
presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking
cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a
physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do
not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.
Lithium Cell
Lithium Cell
Cell Holder
