12
Initial setup
Turn on the TV and the unit
1. Turn on the unit by pressing
ON/STANDBY
or
ON•OFF
.
2. Turn on the TV and select the AV input mode connected
with the unit’s output signal. To do so, you usually press
the AV or INPUT button on the TV remote control until
you get to the video input channel that matches how the
DVD recorder is connected to the TV. When you are on
the right channel, you can see the unit’s player menu.
Setting the clock
1. Press
SETUP
on the remote control to access the player
menus.
2. Press
or
to highlight “Setup”and then press
OK
.
3. Press
or
to highlight “System”and then press
OK
.
4. Press
or
to highlight “Clock”and then press
OK
.
5. Highlight “Year”, “Month”, “Day” and “Time” by
pressing
or
.
6. Press
OK
and then set the value by pressing
or
.
•
For the “Time” setting, press
or
to select among the
hour, minute and AM/PM options before setting their
values.
7. Press
OK
after the setting is done. Press
EXIT/CLEAR
to
exit the clock setting menu.
Since access to a TV’s video input channel varies
from one manufacturer to the next, it is difficult
to provide specific instructions for your particular
brand. Please refer to the user manual of your TV.
Searching for channels
1. Press
SETUP
to access the player menus.
2. Press
or
to highlight “Setup”and then press
OK
.
3. Press
or
to highlight “TV Channel Setup”and then
press
OK
.
4. Press
or
on the action bar at the bottom of the screen
to highlight “Scan”and then press
OK
.
5. Select the input signal type, if necessary, between “Air”
(if antenna is connected) and “Cable” (if cable is
connected) and then press
OK
. Highlight “Yes” and then
press
OK
to continue.
6. The scan operation will overwrite any existing channel
table. Highlight “Yes” and then press
OK
to continue.
Automatic channel search will begin.
•
When the channel search reaches 100%, press
OK
.
•
If no channel list appears, check the ANTENNA/CABLE
input jack to make sure the RF coaxial cable is properly
connected.
AV/INPUT
DRC8335_EN(verB) 7/23/07 3:36 PM Page 14
