RCA BR200DV, Service Manual

Page: 11 / 79

BR200DV/BR300DV
Service Manual
11
1. Install DR-6000 programming software on the computer.
2. As shown in the figure below, connect the radio to the computer through a special serial
or USB programming cable.
Figure 3-1
3.
Turn on the power of the computer.
4.
Turn on the power of the Radio.
5.
Click on
BR200D
icon to perform the program.
6.
In the main menu of the programming software, click on [Read] to read the parameters
of the radio into the computer; click on [Write] to write the parameters set in the
computer into the radio.
Caution:
1. Before editing for the first time, the data should be read from the Radio and properly
backed up.
2. If the edited data cannot work normally after being written into the Radio, please open
the backup data and rewrite them.
3. “Model Information” is the important information of the Radio and should not be altered.
Test Mode
According to Figure 3-1, connect the radio to the computer with the special programming
cable.
Warning:
Before entering the Test Mode, please first connect a high-frequency load of 50
ohm to the antenna port of the radio or connect the radio a certain test instrument.
With the
CPS BR200D/BR300D/BRM300D
Programming Software, you can enter
the adjustment status in Computer Test Mode to adjust the following parameters of the
radio:
（
1
）
Frequency stability
（
2
）
RF transmitting high power
（
3
）
RF transmitting Middle power
（
4
）
RF transmitting Low power
（ 5 ） Maximum TX voice deviation
（
6
）
VOX1(Tight)
（
7
）
VOX10
（
8
）
2/5 tone deviation
（
9
）
DTMF deviation
（ 10 ） MSK deviation
（
11
）
DCS/LTR balance
（
12
）
DCS deviation
Computer
(RS232 serial port
/USB port)
Radio
(Earphone /Program port)
Programming
cable