Setting Recording Mode
You can select between two
recording modes - manual recording
and AVR (automatic voice recording).
1. Manual Recording
1. In
STOP
mode, select folder (A, B,
C , D or
).
2. Press
RECORD
to start recording.
3. To pause recording, you can press
RECORD
once, press again to
resume recording.
4. To stop recording, press
STOP
.
2. AVR (Automatic Voice
Recording)
This feature allows the unit to sense
sound and to record only when you
are speaking into the microphone.
When dictation stops for about 3
seconds, recording will stop and then
start again automatically when you
resume dictation.
1. Select destination folder (A, B, C ,
D or
).
2. Press
MENU
four times.
3. Press
REVERSE
or
FORWARD
to
toggle between AVR on and AVR
off.
4. Press
STOP
to exit to STOP mode.
5. Press
RECORD
to enter AVR mode.
6. During AVR on
recording, adjust
the sensitivity of the
microphone by
pressing
VOL UP
and
VOL DOWN
,
SEN
with sensitivity
value shows on
display (e.g.
increase sensitivity
value when
recording source is
far from the unit or
the recording
envionment is
quiet.).
7. Start dictation.
Recording starts
automatically.
8. Press
STOP
to end AVR recording.
9. Repeat step 2 and select
AVR OFF
for de-selection.
EN
9
Recording Mode
AVR
AVR
SP
DICT
AVR
AM
A
Tip:
To view the remaining time and
other recording information, you
may press
PLAY
during recording.
Tip:
The first syllable or two may be
lost when you start recording
because this ‘sound’ is used to turn
on the AVR feature. It is a good
practice to make some ‘sounds’ or
say a short word to activate the
AVR before you begin actual
dictation.
RP5030 EN (B ver) 15/11/06 10:28 AM Page 14