RC Systems ST-72, Instruction Manual

Page: 31 / 142

ST-72 User's Manual
Document: UM-1007 Revision Level A
25
2.3.4 PROGRAMMABLE RELAY
The 10-0350 Programmable relay option board may be added if the user needs sixteen
more programmable relays in addition to the three standard relays. These 16 relays are
configured through the
PROGRAMMABLE RELAY menus accessed from the
ALARM OUTPUTS menu show in Figure 2-12. Only one Programmable Relay menu
screen is shown because all the Programmable relay’s menus are identical. Under the
PROGRAMMABLE RELAY
menu the user can configure the same parameters as
STANDARD RELAYS discussed in section 2.3.1 .
Alarm Outputs
Standard Relay 2
Standard Relay 3
Horn/Piezo
Discrete Relay
Programmable Relay Brd
Standard Relay 1
~
~
~
~
~
~
Programmable Relay Brd
A2 Votes Required
A3 Votes Required
Acknowledge
Failsafe
Zone 1
Override 1 Channel
A1 Votes Required
0
0
No
No
Yes
0
1
Standard Relay and Programmable
Relay Menus are Identical
Programmable Relay Brd
Programmable Relay 2
Programmable Relay 3
Programmable Relay 4
Programmable Relay 5
" " "
Programmable Relay 16
Programmable Relay 1
~
~
~
~
~
~
~
Figure 2-12
2.4 CHANNEL CONFIGURATION ENTRY MENU
CHANNEL CONFIGURATION
is accessed through the
MAIN MENU.
Once in the
CHANNEL CONFIGURATION entry menu, show on left in Figure 2-13; use /
to scroll up or down to select the channel that is to be configured. Once the
correct channel is selected
Edit
brings you to that channel’s configuration menu, shown
on right below. These items affect only the specific channel selected. System specific
variables are accessed through the
MAIN MENU
shown in Figure 2-1.
Channel 38 Config
Alarm 2
Alarm 3
Fault Alarm
Data From
Linearize
Configure ~
~
~
~
~
~
Alarm 1 ~
Channel Config
Measurment Name Ch.38
46 PCTLEL
Measurment Name Ch.37
1 PCTLEL
Measurment Name Ch.39
6 PCTLEL
Figure 2-13