10
Press and hold the
ENTER
button for 3 seconds to restore the
factory default setting.
Here you have the current software version number and the
charger identification number.
The left side of the first line indicates the battery type you
have selected.
The value on the left side of the second line defines the
charging current.
The value on the right side of the second line defines the
battery voltage.
After adjusting the current and voltage, press the
START/
ENTER
button for more than 3 seconds to start the process
(charging current: 0.1-6.0A, voltage: 2~4S).
Use these programs
only
to charge a lithium battery ( Lilo/LiPo/LiHV/LiFe) with a nominal
voltage of 3.6V, 3.7V, 3.8V or 3.3V per cell, respectively. The charging current entering the
battery varies according to the type of chemistry, so it is
VERY IMPORTANT
to choose the
exact charging mode for your battery. The final charge voltage is also important as it varies
for all four types: 4.1V for Lilo, 4.2V for LiPo, 4.35V for LiHV and 3.6V for LiFe. The charging
current (how many amps you inject into the pack) and the rated voltage (the correct voltage
for the number of cells in the battery you are charging) must be correct for the battery to be
charged. To change these parameters, press the
START/ENTER
button to make the selected
value flash. Use the increase and decrease buttons to set the desired amperage, then press
the
START/ENTER
button to save the setting. You will then be asked to select your nominal
voltage / number of cells. Use the
INC (+) OR DEC (-)
buttons again to reach the desired
setting, then press the
START/ENTER
button to confirm and save.
When you want to change the parameter value in the program, press the
START/ENTER
button to make it blink and then change the value with the INC or DEC button. The value will
be stored by pressing the
START/ENTER
key once.
5. INITIAL PARAMETER SET UP (USER SETUP)
6. LITHIUM BATTERY (LILO-LIPO-LIFE-LIHV) PROGRAM
6.1 LITHIUM BATTERY - CHARGING