CHAPTER 1. INTRODUCTION
3
1.2
Product layout
1.3
Installation
Installation of the PLD-SCC1 Odometer is very simple. The PLD-SCC1
is installed in between your current battery pack or regulated supply
and the receiver/servos/flight-equipment. Take note of the side of
the cabling to use for the battery pack (supply) and the flight equip-
ment (load) - (See figure 1.1) . Because each setup is different, the
PLD-SCC1 is supplied with high current silicon leads which you will
be required to fit your own connectors or connect directly to your
equipment. We recommend using connectors that are rated for 5A
continuous and 10A burst loads, standard “JST” connectors are
not
recommended for any more than 2A continuous loads.