UNC100 Integra/Axiom Light Hardware Manual V1.3 Page
10
of
21
RBH Access Technologies Inc.
RS485 Port Baud Rate Selection
The controller's serial port baud rate is set with controller DIP switches 6 and 7. This setting determines
the speed used to communicate with other controllers. The baud rate must be the same as the baud rate
set for all Integra™ units on the network. The default baud rate is 9600.
Controller Baud Rate Selection
DIP Switch 6
DIP Switch 7
Baud Rate
OFF
OFF
9600
OFF
ON
38400
Host Connection
The controller is connected to the local Ethernet via a static IP address only [default address is
192.168.168.125]. To change the IP address of the unit you can either use IP Locator [a utility program
provided by RBH] or Telnet. The communications configuration is set in the Integra™ software under the
network’s properties under the Comms tab.
PC to UNC100 Connection
PC to UNC100 Connection
For ULC-S319-05
III
compliance, all wiring into the panel’s cabinet must enter through metal conduit.
Also be sure to mount the panel in a protected area.
Name
Defaults
Description and notes
