if all seems ok then pin down the main former and start glueing the ribs with thin ca one by one to the
bottom sheeting, note roll the ribs over the sheeting and apply ca
Place sub leading edge to the bottom sheeting and to the ribs.
Place ailevon leading edge between the ribs to the bottom sheeting.
Place servo and scrap fill for taking horns and hinges
Place servo and wires into the wing , place servos on extra 1,5mm balsa , we shrinked the servo in
shrinking foil and ca them to the bottom sheeting, with a fill on top, make also a opening for the servo
arm in the bottom sheeting.cut the top sheeting as per plan.
Note the X marked positions on the drawing
