LED
Your UB1 may not have a fully charged battery; therefore you must charge the battery prior to use. Be sure to charge
the battery in a clean, dry location away from direct sunlight, flames or sparks.
• Initial charge time: 5 hours.
• Recharge time: up to 4 hours, even if the light
turns green. Recommended maximum charging time
is 24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure the power button is turned
OFF
when
product is not in use. If the power button is left on for
an extended period of time, the battery may reach a
stage at which it will no longer hold a charge.
• Run time: Up to 40 minutes of continuous ride time.
Run time may vary depending on riding conditions,
rider weight, climate, and/or proper maintenance.
• Constant starting and stopping may shorten ride time.
• Battery life can vary depending on proper
maintenance and usage of the product.
• Do not charge at or below 32°F (0°C).
2
Note:
Make sure power button is
in the
OFF
position. Plug the charger
into the charger port. The light on
the charger should turn red during
charging. The light will turn green
again when charging is complete.
1
Plug the charger plug into wall
outlet. The light on the charger
should be green.
Note:
If green light (LED) does not
turn on, try a different outlet.
Charger
(
Note:
Charger design may vary
from one shown)
WARNING:
Use ONLY with
the recommended charger. Batteries
are only to be charged under adult
supervision. The charger is not a
toy. Always disconnect the charger
before wiping down and/or cleaning
the UB1 with a damp cloth.
The charger supplied with the UB1
should be regularly examined for
damage to the cord, plug, enclosure
and other parts. In the event of
such damage, the UB1 must not be
charged until it has been repaired or
replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Wall outlet - Green (stand by)
Wall outlet and product -
Red (charging)
Wall outlet and product -
Green (charged)
Note:
Continue charging product
even if light turns green prior to
4 hours.
WARNING:
Battery charge
can deplete over time. Periodically
recharge battery when not in use.
Brake
Check the brake for proper function. When you squeeze the
lever, the brake should provide positive braking action. When
you apply the brake with the throttle on/engaged, the brake
cut-off switch should cut power to the motor.
Wheels
Periodically inspect the wheels for excessive wear.
Tire
Periodically inspect the tire for excess wear and replace as
needed. Regularly check the tire pressure and inflate
as needed.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken
frames are rare, it is possible for an aggressive rider to run into
a curb or object and wreck, bend or break a frame. Get in the
habit of inspecting your scooter on a regular basis.
Hardware/Loose Parts
Before every ride, check all parts, such as nuts, bolts, fasteners,
etc., to ensure they are secure and assembled correctly. There
should not be any unusual rattles or sounds from loose parts
or broken components. If the product is damaged, do not ride.
Reference “Safety Warnings” on pages 1 and 2 of
this manual.
Safety Gear
Always wear proper protective equipment, such as an approved
safety helmet (with chin strap securely buckled), elbow pads,
and kneepads. A helmet may be legally required by local law or
regulation in your area. A long-sleeved shirt and long pants are
recommended. Always wear shoes and keep shoelaces tied and
out of the way of the wheels and motor. Never ride barefooted or
in sandals.
Laws and Regulations
Always check and obey any local laws or regulations.
Insurance
Do not assume that your existing insurance policies necessarily
provide coverage for product use. Check with your insurance
company for information regarding insurance.
Model
Voltage
(Nominal) Vdc
Capacity
(Nominal) Ah
Charge
Temperature Range
Operating
Temperature Range
UB1
37
3.2
0° to 40°C
32° to 104°F
-10° to 40°C
14° to 104°F
PRE-RIDE CHECKLIST
7
CHARGING THE BATTERY
