Razor Trikke E2, Owner'S Manual, Page: 6 / 15

5
Need Help?
Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the white label on your product or back of charger) available for better assistance.
CHARGING THE BATTERY
q
Charging the Battery
Charge the battery prior to use.
• Initial charge time: 12 hours.
• Recharge time: up to 12 hours, even if the light turns
green. Recommended maximum charging time is 24
hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended periods
of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure scooter power switch is turned OFF when
unit is not in use. If the power switch is left on for an
extended period of time, the battery may reach a stage
at which it will no longer hold a charge.
• To ensure long battery life, never store the product in
freezing or below freezing temperatures! Freezing will
permanently damage the battery.
• Run time: Up to 40 minutes of continuous ride time.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
• Constant stopping and starting may shorten ride time.
• Average battery life for a properly maintained unit is
approximately 250 charge/discharge cycles.
WARNING:
Battery
charge can deplete over time.
Periodically recharge battery when
not in use.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your scooter
from the charger before cleaning
with damp cloth.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED light to indicate
the charge status. Refer to the
illustration on the charger unit
for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Charger may get warm during use.
This is normal for some chargers
and is no cause for concern. If your
charger does not get warm during
use, it does not mean that it is not
working properly.
Charger
1
Plug the charger into a wall
outlet. If the lights on charger
do not light up, check the power
to the outlet. If necessary, try a
different outlet.
2
Turn the power switch OFF
before charging. Plug the charger
into the charger port on the side
of the battery compartment.