Razor Trikke E2, Owner'S Manual, Page: 3 / 15

2
Need Help?
Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the white label on your product or back of charger) available for better assistance.
Remove contents from box. Remove the packaging separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the scooter is 50 percent assembled and packed at the factory, there should not be any problems, even if the box
has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE
PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 30 minutes for assembly, not including initial charge time. Two people are recommended for assembly.
Allow up to 12 hours for initial charge (see page 5 for charging information).
BEFORE YOU BEGIN
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR RAZOR ELECTRIC
SCOOTER. The scooter has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket parts may or may not
be compatible and may void your
warranty.
Required Tools
Note : Trikke E2 must be moving
at 3mph/5kmh while applying the
throttle to engage motor.
Product ID Locations:
See locations to the left
1. Stem
2. Battery Tray
3. Charger (not shown)
4. UPC Side of Box (not shown)
Two (2) 5mm Allen Wrenches
(Included)
Stem Handlebar
Collar
Clamp
Front Wheel
Motor
Chain Guard
Charger
Port
On/Off
Switch
2 Battery
Compartments
Brake
Throttle
Rear Wheels
Platforms
8mm and 13mm Open Wrenches
(Not Included)