background image

7

Vehicle does not run

Vehicle was running but

suddenly stopped

 

Short run time (less than  

30 minutes per charge)

 

 

Vehicle runs sluggishly

 

 

 

Problem 

Possible Cause 

Solution

Undercharged battery

Charger is not working

Loose wires or connectors

Tripped circuit breaker

 

Undercharged battery

Battery is old and will not accept 

full charge

 

 

Brakes are not adjusted properly 

Driving conditions are too stressful

 

Tires are not properly inflated

Vehicle is overloaded

Charge the battery. A new battery should have been charged for at least 12

hours before using the vehicle for the first time and up to 8 hours after each 

subsequent use.

Check all connections. Make sure the charger port is tightly plugged into the 

charging port on the Pocket Mod, and that the charger is plugged into the 

wall.

Make sure power flow to the wall outlet is on.

You may check to see if your charger is working by using a volt meter or 

asking your local Razor authorized service center to test your charger for you.

Check all wires and connectors to make sure they are tight.

The circuit breaker (next to on/off switch) will automatically shut off the

power if the motor is overloaded.

 

An excessive overload, such as too heavy a rider or too steep a hill, could

cause the motor to overheat. If the Pocket Mod suddenly stops running,

wait a few seconds and then push the breaker to reset the circuit. Correct the

conditions that caused the breaker to trip and avoid repeatedly tripping

the breaker.

Charge the battery. A new battery should have been charged for at least 12 

hours before using the vehicle for the first time and up to 8 hours after each 

subsequent use.

 

Check all wires and connectors. Make sure the battery connector is tightly 

plugged into the charger connector, and that the charger is plugged into  

the wall.

Make sure power flow to the wall outlet is on.

Even with proper care, a rechargeable battery does not last forever. Average 

battery life is 1 to 2 years depending on vehicle use and conditions. Replace 

only with a Razor replacement battery.

Refer to adjusting the brakes instructions on page 4. 

 

Use only on solid, flat, clean and dry surfaces such as pavement or level 

ground.

The tires are inflated when shipped, but they invariably will lose some

pressure between the point of manufacturing and your purchase.  

Refer to instructions on page 4.

Make sure you do not overload the vehicle by allowing more than one rider  

at one time, exceeding the 220 lb. maximum weight limit, going up a hill 

or towing objects behind the vehicle. If the vehicle is overloaded, the 

circuit breaker may trip and shut off power to the motor. Correct the driving 

conditions that caused the overload, wait a few seconds, and then push the 

breaker to reset the circuit. Avoid repeatedly tripping the circuit breaker.

 

 

 TROUBLESHOOTING GUIDE

Summary of Contents for Pocket Mod Motor Scooter















Reviews: